Growth that runs in straight lines is telling you something about the structure. In the concrete-framed and system-built blocks that make up a large part of the housing in IG11, mould does not appear in vague patches - it maps out a rectangle around the ceiling line, a vertical band a foot wide down one section of wall, and a matching band in the same position in the flat above. What it is tracing is the concrete inside the wall.
What a frame does to the inside face
In a framed building the floor slabs, columns and edge beams pass straight through the line of the insulation. Concrete conducts heat far better than the infill panel around it, so the internal plaster directly over a slab edge or a column sits several degrees colder than the wall a hand's width away. That is a thermal bridge, and in winter those cold strips drop below the dew point of the room air while the rest of the wall stays above it. The condensation, and the growth that follows, lands only on the cold lines. It is geometry, and no amount of household routine will change it.
Panel joints in system-built blocks
Large-panel construction adds a second pattern. The joints between precast panels were sealed and insulated at manufacture, and after decades the sealant has hardened, the joint insulation has slumped, and water can track into the joint from outside. Growth then appears along a vertical and horizontal grid that corresponds exactly to the panel layout, sometimes with staining that follows rain rather than temperature. Distinguishing a cold joint from a wet joint decides whether the remedy is thermal or a repair to the external seal. The same detailing turns up in later blocks elsewhere in the borough, covered under trusted condensation treatment in Woodford Green.
Why lining a wall can make matters worse
Insulated board fixed over the visible cold strip and stopped at its edges moves the bridge rather than removing it: the cold line simply reappears a few centimetres to one side, at the edge of the new board. A lining has to be returned around the junction, carried past the bridge onto the adjoining surface, and fitted with a vapour control layer on the room side that is genuinely continuous and sealed at every edge and service penetration. A gap in that layer lets moist air into the space behind the board, where it condenses out of sight and rots the fixings. The specification used and what the guarantee covers is set out on our mould removal and remediation team.
Ground-floor flats on low ground
The ground here is low-lying and the water table sits close to the surface, which bears on ground-floor and undercroft flats in particular. Floor slabs stay cold, perimeter ducts run damp, and a service void alongside a habitable room stays humid all year. Those same voids and duct runs are the routes rodents use to move under a block, and droppings in a perimeter duct are a frequent incidental finding during an inspection. Where that happens, Barking pest control team treats it across the block rather than in the single flat where it was noticed.
Who instructs the work
Much of this stock is managed by a housing provider or a residents' management company, and thermal bridging in the structure is not a repair an individual resident can carry out. External wall insulation to the whole elevation is the proper answer and is a major works matter. Meanwhile the internal measures - returned lining to the affected junctions, improved extract, vents reinstated, plaster made good - can proceed inside a single flat, and our handyman in Barking covers the boarding, joinery and finishing that goes with them.
Access and what a visit involves
An inspection is built around surface temperatures rather than moisture alone, since the diagnosis rests on how cold the bridge runs relative to the room air. Readings are taken on and off the cold line at matched heights, in more than one room where a pattern repeats, and compared against the flat above or below where access allows. Lifts have to be available for equipment in the taller blocks and a concierge or estate office generally needs notice. Pricing follows the area of lining and the number of junctions detailed. Rooms disturbed by boarding and plastering want a full clean afterwards, and Buckhurst Hill domestic cleaning service handles it.