A cat flap looks like the simplest item on any list of jobs, and in a modern flat around SE16 it is frequently the one that cannot be done at all. The reason is the door: almost everything fitted in the last thirty years is either a sealed double-glazed unit, a composite slab with a foam core, or a fire door, and each of those responds badly to having a hole cut in it.
Toughened glass cannot be cut, only replaced
The glass in a modern door or a side panel is toughened, and toughening is a heat treatment that puts the pane under permanent internal stress. Cutting or drilling it releases that stress and the whole pane disintegrates into fragments. There is no technique, no blade and no amount of care that changes this. The only route through a glazed panel is to order a replacement sealed unit manufactured with the aperture already in it, measured from the existing unit's sight size and the frame's rebate depth.
Composite and uPVC doors
A composite door has a rigid foam core between two skins, and cutting an opening exposes that core at the edges. The aperture has to be sealed around its full perimeter so water and air cannot get into the core, and the flap chosen needs a tunnel deep enough for the door's thickness, which is usually greater than a timber door. uPVC doors contain reinforcement sections and sometimes the multipoint lock mechanism in places that are not obvious from outside, and cutting through either is irreversible.
Fire doors and communal entrances
A flat entrance door in a block is almost always a fire door, and cutting any opening through it destroys its certification. That applies to a cat flap, a letterplate and a ventilation grille alike. Where a pet needs access in a flat of this kind, the opening goes somewhere else entirely — an external wall, a panel in a rear door, or a purpose-made unit in a window. Communal doors are not an option at all. The same door types and the same limits apply in the adjoining district covered by trusted TV wall mounting in Rotherhithe.
Going through a wall instead
A wall tunnel is often the better answer and is a more substantial piece of work. The opening is cored or cut, a tunnel liner takes it through the full wall thickness, and on a cavity wall the cavity is closed around the opening so it does not become a route for air, water or anything else. The position matters as much as the method: clear of any buried service, clear of the lintel over a nearby opening, at a height an animal can reach comfortably from both sides, and not somewhere that leaves a step down onto a flight of stairs. Where the plaster around an existing tunnel has already darkened, the surface is treated under trusted mould remediation in Surrey Quays.
Letterplates and other apertures in the same doors
The same constraints apply to a letterplate being moved or enlarged, a ventilation grille being added to a utility room door, or a spyhole going into a composite slab. Each is a hole through a manufactured assembly with a structure that has to be understood first. An aperture cut into a timber door is by comparison straightforward, provided it stays clear of the rails and stiles that give the door its strength, and provided the cut is sealed so the exposed end grain does not take up moisture. A door with an integrated light or entry release adds a further constraint, and any connection there is work for electrical services throughout Dulwich.
Security, once there is an opening
Any aperture in a door is a weak point, and a flap within reach of a latch or a thumbturn is a known risk. Microchip-operated units reduce unwanted visitors but do nothing about the hole itself. Fitting a lockable flap, keeping it away from the lock line, and adding a thumbturn shield where one is close by are the sensible mitigations. Openings at low level in a wall or a door also admit others besides the intended pet, and where that becomes apparent the answer is pest control specialists in Surrey Quays rather than a larger flap.
Establishing what is possible first
A photograph of the whole door and a close-up of its edge, plus the make if it is known, allows a realistic answer about whether an opening is possible before anything is ordered. In a leasehold flat the lease and the building's rules are worth checking, since altering a door or an external wall may need consent. Where a replacement glazed unit is required, the survey and the fitting are separate visits. The wider list of tasks is on how it works.